Seat belts

The seat belts can be cleaned by wiping them with a sponge dampened in a mild soap solution.

Allow the belts to dry completely in the shade before using them. See “Seat belt maintenance” in the “Safety – Seats, seat belts and supplemental restraint system” section of this manual.

Do not allow wet seat belts to roll up in the

Do not allow wet seat belts to roll up in the retractor. NEVER use bleach, dye or chemical solvents to clean the seat belts, since these materials may severely weaken the seat belt webbing.

    See also:

    If your vehicle overheats
    - Do not continue to drive if your vehicle overheats. Doing so could cause engine damage or a vehicle fire. - To avoid the danger of being scalded, never remove the radiator cap while t ...

    Volume control switch
    Push the volume control switch up or down to increase or decrease the volume. Tuning Memory change (radio): Push the tuning switch ( or ) for less than 1.5 seconds to change presets. Seek t ...

    Manual transmission (if so equipped)
    ● Do not downshift abruptly on slippery roads. This may cause a loss of control. ● Do not over-rev the engine when shifting to a lower gear. This may cause a loss of control or ...