Compass (if so equipped)

When the ignition switch is turned to the ON

When the ignition switch is turned to the ON position, the compass display B will indicate the direction of the vehicle’s heading.

If the display reads “C”, calibrate the compass

If the display reads “C”, calibrate the compass by driving the vehicle in 3 complete circles at less than 5 MPH (8 km/h). You can also calibrate the compass by driving your vehicle on your everyday route. The compass will be calibrated once it has tracked 3 complete circles.

To turn on and off the compass manually, push the A while the ignition switch is in switch A while the ignition switch is in the ON position.

See also:

Emission control information label
The emission control information label is attached to the underside of the hood as shown. ...

Change intervals
The oil and oil filter change intervals for your engine are based on the use of the specified quality oils and filters. Using engine oil and filters that are not of the specified quality, or exc ...

Engine compartment
CAUTION: Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or cause a fire. If any electrical equipment does ...