Heater operation

Heating:

This mode is used to direct heated air to the foot outlets.

1. Push the air recirculation button to the to the OFF position. (The indicator light turns off.) 2. Turn the air flow control dial to the position. position.

3. Turn the fan speed control to the dial to the desired position.

4. Turn the temperature control dial to the desired position between the middle and the hot (right) position.

Ventilation:

This mode directs outside air to the side and center ventilators.

1. Push the air recirculation button to the to the OFF position. (The indicator light turns off.) 2. Turn the air flow control dial to the position. position.

3. Turn the fan speed control to the dial to the desired position.

4. Turn the temperature control dial to the desired position.

Defrosting or defogging:

This mode directs the air to the defroster outlets to defrost/defog the windows.

1. Turn the air flow control dial to the position.

2. Turn the fan speed control dial to the desired position. desired position.

3. Turn the temperature control dial to the dial to the desired position between the middle and the hot (right) position.

- To remove frost from the outside surface of the windshield quickly, turn the temperature control dial to the maximum hot position and the fan speed control maximum dial to maximum (HI) position.

- If it is difficult to defog the windshield, turn the A/C button on.

Bi-level heating:

This mode directs cool air from the side and center vents and warm air from the foot outlets.

When the temperature control dial is turned to the maximum hot or cool position, the air between the ventilators and the foot outlets is the same temperature.

1. Push the air recirculation button to the to the OFF position. (The indicator light turns off.) 2. Turn the air flow control dial to the position. position.

3. Turn the fan speed control to the dial to the desired position.

4. Turn the temperature control dial to the desired position.

Heating and defogging:

This mode heats the interior and defogs the windows.

1. Turn the air flow control dial to the position. position.

2. Turn the fan speed control to the dial to the desired position.

3. Turn the temperature control dial to the desired position.

    See also:

    Seat belts with pretensioners (front seats)
    - The pretensioners cannot be reused after activation. They must be replaced together with the retractor and buckle as a unit. - If the vehicle becomes involved in a collision but a prete ...

    Seat belt warning light and chime
    The light and chime remind you to fasten your seat belts. The light illuminates whenever the ignition switch is placed in the ON or START position and remains illuminated until the driver’s se ...

    FM/AM radio operation
    FM/AM band select: Pressing the RADIO button will change the band as follows: AM ←→ FM When the RADIO button is pressed while the ignition switch is in the ACC or ON position, the ra ...