Checking engine oil level

1. Park the vehicle on a level surface and apply

1. Park the vehicle on a level surface and apply the parking brake.

2. Run the engine until it reaches operating temperature.

3. Turn off the engine. Wait more than 10 minutes for the oil to drain back into the oil pan. 4. Remove the dipstick and wipe it clean.

Reinsert it all the way.

5. Remove the dipstick again and check the oil level. It should be within the range 1 . If the oil level is below 2 , remove the oil filler cap and pour recommended oil through the opening. Do not overfill 3 .

6. Recheck oil level with the dipstick.

It is normal to add some oil between oil maintenance intervals or during the breakin period, depending on the severity of operating conditions.

Oil level should be checked regularly.

Oil level should be checked regularly.

Operating the engine with an insufficient amount of oil can damage the engine, and such damage is not covered by warranty.

    See also:

    Continuously Variable Transmission (CVT) position indicator light (if so equipped)
    When the ignition switch is placed in the ON position, this indicator light shows the shift selector position. See “Driving the vehicle” in the “Starting and driving” section of this manu ...

    Universal Serial Bus (USB) memory (if so equipped)
    This system supports various USB memory sticks, USB hard drives and iPod players. There are some USB devices which may not be supported with this system. ● Make sure that the USB device i ...

    A Cube With a View
    The Cube is a few inches narrower than its boxy competitors, but it has plenty of headroom. Proving again that dimensions don't tell the whole story, the Cube's front seat could use a little more ...