Vehicle set-up
1. Park the vehicle on a level surface and apply the parking brake.
2. Start the engine and let it idle until it reaches operating temperature.
3. Turn the engine off and wait more than 10 minutes.
4. Raise and support the vehicle using a suitable floor jack and safety jack stands.
- Place the safety jack stands under the vehicle jack-up points.
- A suitable adapter should be attached to the jack stand saddle.
Make sure the correct lifting and support points are used to avoid vehicle damage.
See also:
Emission control information label
The emission control information label is attached
to the underside of the hood as shown. ...
Bluetooth Hands-Free Phone System (if so equipped)
● Use a phone after stopping your vehicle
in a safe location. If you have to use a
phone while driving, exercise extreme
caution at all times so full attention may
be given to vehicl ...
Checking engine coolant level
Check the coolant level in the reservoir when
the engine is cold. If the coolant level is below
the MIN level 2 , open the reservoir cap and
add coolant up to the MAX level 1 . If the
reserv ...