Tire chains

NISSAN recommends using the following

NISSAN recommends using the following tire cables made by Peerless Chain Company for this vehicle due to limited tire clearance. Call 800-533-8056 to order tire chains for your vehicle.

- 215/70R16 - Sno-trac1000 part number 0103855 with chain tightener part number 2007020
- 225/60R17, 225/55R18 - Snotrac1000 part number 0103855 with chain tightener part number 2007190
Failure to use the correct traction device will cause damage to the brakes, suspension or other vehicle parts.

The tire chain part numbers and Peerless Chain Company phone number are correct at the time of printing that is shown on the back cover of this Owner’s Manual. Always confirm the correct part numbers with Peerless Chain Company before ordering.

Only use other types of traction devices if the traction device manufacturer recommends it for use on your specific vehicle and the tire and wheel installed on your vehicle.

Use of traction devices may be prohibited according to location. Check the local laws before installing traction devices. When installing traction devices, make sure they are the proper size for the tires on your vehicle and are installed according to the traction device manufacturer’s suggestions. When using traction devices, avoid fully loading your vehicle and drive at reduced speeds. Failure to do so may cause damage to the brakes and suspension and adversely affect handling and performance.

Traction devices must be installed only on the front wheels and not on the rear wheels.

Do not drive with traction devices on paved roads that are clear of snow. Driving with traction devices in such conditions can cause damage to the various mechanisms of the vehicle due to some overstress.

- Do not use traction devices on dry

- Do not use traction devices on dry roads.

- Never install traction devices on a Ttype spare tire as doing so could damage the brakes, suspension or other vehicle parts.

    See also:

    Installing covers to rear parcel shelf
    CAUTION Make sure that the hinge is completely aligned with the pin. If the pin is forced into position, it may break. Install the top tether anchor cover or key cylinder cover as follows: 1. ...

    Tilting the moonroof
    Close the moonroof by pushing the switch toward 2 . Release the switch, then push the switch toward 2 again to tilt the moonroof up. To tilt the moonroof down, push the switch toward 1 . ...

    Rear window and outside mirror defroster switch
    To defog/defrost the rear window glass and outside mirrors (if so equipped), start the engine and push the switch on. The indicator light 1 will illuminate. Push the switch again to turn the ...