Checking bulbs

With all doors closed, apply the parking brake and place the ignition switch in the ON position without starting the engine. The following lights will come on:

If equipped, the following lights come on briefly

If equipped, the following lights come on briefly and then go off:

If any light fails to come on, it may indicate

If any light fails to come on, it may indicate a burned-out bulb or an open circuit in the electrical system. Have the system repaired promptly.

    See also:

    Locking doors
    1. Turn the ignition switch to the LOCK position.1 2. Carry the Intelligent Key with you. 3. Close all the doors.2 4. Push the LOCK button 1 on the Intelligent Key. 5. All the doors and the ...

    Clearing the programmed information
    Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds) ...

    Programming HomeLink
    1. To begin, press and hold the two outer HomeLink buttons (to clear the memory) until the indicator light (1) blinks (after 20 seconds). Release both buttons. 2. Position the end of the hand ...