Reprogramming a single HomeLink button

Nissan Maxima / Nissan Maxima Owners Manual / Instruments and controls / Reprogramming a single HomeLink button

To reprogram a HomeLink Universal Transceiver button, complete the following.

1. Press and hold the desired HomeLink button.

Do not release the button until step 4 has been completed.

2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface.

3. Press and hold the hand-held transmitter button.

4. The HomeLink indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons.

The HomeLink Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink button that was just programmed. This procedure will not affect any other programmed HomeLink buttons.

    See also:

    Suggested maximum speed in each gear
    Downshift to a lower gear if the engine is not running smoothly, or if you need to accelerate. Do not exceed the maximum suggested speed (shown below) in any gear. For level road driving, use t ...

    Dimensions and weights
    ...

    Rear-facing child restraint installation using LATCH
    Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint. Follow these steps to install a rear-facing child restraint ...