System operation
The automatic drive positioner system will not work or will stop operating under the following conditions:
- When the vehicle speed is above 4 MPH (7 km/h).
- When any of the memory switches are pushed while the automatic drive positioner is operating.
- When the adjusting switch for the drivers seat is turned on while the automatic drive positioner is operating.
- When the seat has been already moved to the memorized position.
- When no seat position is stored in the memory switch.
- When the shift selector is moved from P (Park) to any other position.
- When the drivers door remains open more than 45 seconds and the ignition switch is not in the ON position.
The automatic drive positioner system can be adjusted and canceled for vehicles with navigation system. See Comfort & Convenience settings in the Monitor, climate, audio, phone and voice recognition systems section of this manual.
See also:
Brake and clutch (if so equipped) fluid
For further brake and clutch fluid specification
information, refer to “Capacities and recommended
fuel/lubricants” in the “Technical and
consumer information” section of this manual.
WARN ...
Seat belts with pretensioners (Front
seats)
WARNING
● The pretensioners cannot be reused after
activation. They must be replaced
together with the retractor and buckle
as a unit.
● If the vehicle becomes involved in a
collisio ...
Supplemental air bag warning light
The supplemental air bag warning light, displaying
in the instrument panel, monitors the
circuits of the supplemental front-impact air bag,
front seat-mounted side-impact supplemental
air ...