NISSAN Intelligent Key

Replace the battery in the Intelligent Key as follows:

1. Remove the mechanical key from the Intelligent Key.

2. Insert a small screwdriver (A) into the slit (B)- of the corner and twist it to separate the upper part from the lower part. Use a cloth to protect the casing.

3. Replace the battery with a new one.

Recommended battery: CR2032 or equivalent.

- Do not touch the internal circuit and electric terminals as doing so could cause a malfunction.

- Hold the battery by the edges. Holding the battery across the contact points will seriously deplete the storage capacity.

- Make sure that the + side faces the bottom of the case.

4. Close the lid securely as illustrated (C)- (D).

4. Close the lid securely as illustrated (C)- (D).

5. Operate the buttons to check the operation.

See a NISSAN dealer if you need assistance for replacement.

FCC Notice:

Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.

This device complies with Part 15 of the FCC Rules and RSS-210 of Industry Canada.

Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.

    See also:

    Draining of coolant water
    If the vehicle is to be left outside without antifreeze, drain the cooling system, including the engine block. Refill before operating the vehicle. For details, see “Changing engine coolant” ...

    Vehicle Dynamic Control (VDC) system
    The Vehicle Dynamic Control (VDC) system uses various sensors to monitor driver inputs and vehicle motion. Under certain driving conditions, the VDC system helps to perform the following funct ...

    Steering wheel switch for audio control (if so equipped)
    Type A 1. Tuning switch 2. MODE select switch 3. POWER on/off switch 4. Volume control switch Type B 1. Tuning switch 2. Phone operation switch 3. POWER on and MODE select switch 4. ...