Install

1. Align the head restraint stalks with the holes

1. Align the head restraint stalks with the holes in the seat. Make sure the head restraint is facing the correct direction.
2. Push and hold the lock knob and push the head restraint down.
3. Properly adjust the head restraint before an occupant uses the seating position.

    See also:

    Removing the bolt-on wheel cover (if so equipped)
    CAUTION Do not use your hands to pry off wheel caps or wheel covers. Doing so could result in personal injury. The wheel covers are held on by the wheel nuts. The wheel cover will be removed al ...

    Air conditioner operation
    Start the engine, turn the fan control dial to the desired position, and push in the button to activate the air conditioner. When the air conditioner is on, cooling and dehumidifying functions are ...

    All-Wheel Drive (AWD) lock switch operations
    The AWD LOCK switch located on the lower side of the instrument panel. This switch is used to select the AUTO or LOCK mode depending on the driving conditions. Each time you push the lower pa ...