Moonroof
When power window switch does not operate
If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system:
1. Place the ignition switch in the ON position.
2. Open the window more than halfway by operating the power window switch.
3. Pull the power window switch and hold it to close the window, and then hold the switch more than 3 seconds after the window is closed.
4. Release the power window switch. Operate the window by the automatic function to confirm the initialization is complete. The power window automatically opens or closes depending on if the automatic down or up function is selected.
5. Perform steps 2 through 4 above for other windows. If the power window function does not operate properly after performing the above procedure, see a NISSAN dealer for assistance.
See also:
Locking doors
1. Remove the key from the ignition switch.
2. Close all the doors.
3. Push the LOCK button 1 on the
keyfob.
4. All the doors will lock.
All of the doors will lock when the LOCK
button is pu ...
Opener operation
WARNING:
- Do not drive with the trunk lid open. This
could allow dangerous exhaust gases
to be drawn into the vehicle. See Exhaust
gas in the Starting and driving
section of this manual.
...
Changing a flat tire
If you have a flat tire, follow the instructions below: ...