Checking bulbs

With all doors closed, apply the parking brake and place the ignition switch in the ON position without starting the engine. The following lights will come on:

If equipped, the following lights come on briefly

If equipped, the following lights come on briefly and then go off:

If any light fails to come on, it may indicate

If any light fails to come on, it may indicate an open circuit in the electrical system.

Have the system repaired promptly.

    See also:

    Readiness for Inspection/Maintenance (I/M) test
    A vehicle equipped with All-Wheel Drive (AWD) should never be tested using a two wheel dynamometer (such as the dynamometers used by some states for emissions testing), or similar equipment. M ...

    Vents
    Center Adjust air flow direction by moving the vent slides. Open or close the vents by using the dial. Move the dial toward the to open the vents or toward the to close them. Side Re ...

    Auto-reverse function (if so equipped)
    There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the ...