Manual command selection
Commands can be selected manually. While the
commands are displayed on the audio screen,
select a command by operating the audio tuning
switch, and then push the 
switch.
Once a
command is manually selected, the voice
command function is cancelled. To return to
voice command mode, push the 
switch
to
cancel the current operation, and then perform
the first procedure of voice command.
See also:
Headlight beam select
1 To select the high beam function, push the
lever forward. The high beam lights come on
and the light illuminates.
2 Pull the lever back to select the low beam.
3 Pulling and releasing the lev ...
LATCH lower anchor location
LATCH lower anchor location
The LATCH anchors are located at the rear of
the seat cushion near the seatback. A label is
attached to the seatback to help you locate the
LATCH anchors. ...
Power steering fluid
The fluid level should be checked using the HOT
MAX range on the power steering fluid reservoir
at fluid temperatures of 122° - 176°F (50° -
80°C) or using the COLD MAX range on the
powe ...