If your vehicle is stolen
If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink. Consult the Owners Manual of each device or call the manufacturer or dealer of those devices for additional information.
When your vehicle is recovered, you will need to reprogram the HomeLink Universal Transceiver with your new transmitter information.
FCC Notice:
This device complies with FCC rules part 15 and RSS-210 of Industry Canada. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and (2) This device must accept any interference that may be received, including interference that may cause undesired operation.
This transmitter has been tested and complies with FCC and DOC/MDC rules.
Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
DOC: ISTC 1763K1313.
FCC I.D. CV2V67690.
See also:
Giving voice commands
To operate NISSAN Voice Recognition, press
and release the button located on
the
steering wheel. After the tone sounds, speak a
command.
The command given is picked up by the microphone,
and v ...
Tilt operation
Tilt operation
Push the lock lever 1 down and adjust the
steering wheel up or down 2 to the desired
position.
Pull the lock lever up to lock the steering wheel in
place.
Do not adjust t ...
Turn signal/hazard indicator
lights
The appropriate light flashes when the turn signal
switch is activated.
Both lights flash when the hazard switch is turned
on. ...