Choosing a language

You can interact with the Bluetooth Hands-Free Phone System using English, Spanish or French. To change the language, perform the following.

1. Press and hold the more button for more than 5 seconds.

2. The system announces: “Press the PHONE/SEND (hands-free phone system to enter the ) button for the hands-free phone system to enter the speaker adaptation mode or press the PHONE/END (different ) button to select a different language.”

3. Press the For information on speaker adaptation, see button. For information on speaker adaptation, see “Speaker Adaptation (SA) mode”in this section.

4. The system announces the current language and gives you the option to change the language to Spanish (in Spanish) or French (in French). To select the current language, press the PHONE/SEND (select a different language, tilt the tuning ) button. To select a different language, tilt the tuning switch ( or ) up or down.

NOTE:

You must press the 5 button within 5 seconds to change the language.

5. If you decide not to change the language, do not press either button. After 5 seconds, the VR session will end, and the language will not be changed.

    See also:

    Push starting
    Do not attempt to start the engine by pushing. Continuously Variable Transmission (CVT) models cannot be push-started or tow-started. Attempting to do so may cause transmission damage. ...

    Around viewTM monitor (if equipped)
    The CAMERA button is located on the center console. When you push the CAMERA button or shift the selector lever into the “R” (Reverse) position while the ignition switch is in the ON posi ...

    Power outlet
    Instrument panel The power outlets are for powering electrical accessories such as cellular telephones. They are rated at 12 Volt, 120W (10A) maximum. The power outlet located on the bottom ce ...