Engine block heater (if so equipped)

WARNING

● Do not use your engine block heater with an ungrounded electrical system or a 2-pronged adapter. You can be seriously injured by an electrical shock if you use an ungrounded connection.

● Disconnect and properly store the engine block heater cord before starting the engine. Damage to the cord could result in an electrical shock and can cause serious injury.

● Use a heavy-duty 3-wire, 3-pronged extension cord rated for at least 10 A. Plug the extension cord into a Ground Fault Interrupt (GFI) protected, grounded 110-VAC outlet. Failure to use the proper extension cord or a grounded outlet can result in a fire or electrical shock and cause serious personal injury.

Engine block heaters are available through NISSAN dealers to assist in cold temperature starting. The engine block heater should be used when the outside temperature is 20° F (-7° C) or lower.

To use the engine block heater:

1. Turn the engine off.
2. Open the hood and unwrap the engine block heater cord.
3. Plug the engine block heater cord into a grounded 3-wire, 3-pronged extension cord.
4. Plug the extension cord into a Ground Fault Interrupt (GFI) protected, grounded 110- volt AC (VAC) outlet.
5. The engine block heater must be plugged in for at least 2 - 4 hours, depending on outside temperatures, to properly warm the engine coolant. Use an appropriate timer to turn the engine block heater on.
6. Before starting the engine, unplug and properly store the cord to keep it away from moving parts.

    See also:

    Rogue in the Market
    Some shoppers will be put off by the Rogue's poor sight lines, but I suspect the majority will respond to the crossover with a collective shrug. When similar money can buy a handsome interior, a v ...

    Safety, Features & Pricing
    In crash tests by the Insurance Institute for Highway Safety, the Rogue earned the top score, Good, in front, side and rear impacts. The crossover earned just an Acceptable score in roof-strength ...

    Clock
    The following display will appear after pressing the SETTING button, then selecting the “Clock” key. On-screen Clock: When this item is enabled (indicator light illuminated), a clock is alw ...