Hood

Hood
1. Pull the hood lock release handle 1 located below the instrument panel until the hood springs up slightly.
2. Locate the lever 2 in between the hood and grille and push the lever sideways with your fingertips.
3. Raise the hood 3 .
4. Remove the support rod 4 and insert it into the slot on the underside of the hood 5 .
When closing the hood, return the support rod to its original position, lower the hood to approximately 12 inches (30 cm) above the latch and release it. This allows proper engagement of the hood latch.

● Make sure the hood is completely closed and latched before driving. Failure to do so could cause the hood to fly open and result in an accident.
● If you see steam or smoke coming from the engine compartment, to avoid injury do not open the hood.
See also:
Safety
Standard safety features include antilock brakes, side-impact airbags for the
front seats and side curtain airbags. V-6 models add an electronic stability
system.
For a full list of safety featu ...
Uniform tire quality grading
DOT (Department of Transportation) Quality
Grades: All passenger car tires must conform to
federal safety requirements in addition to these
grades.
Quality grades can be found where applicable on
...
Clearing the programmed information
Individual buttons cannot be cleared, however to
clear all programming, push and hold the two
outside buttons and release when the indicator
light begins to flash (in approximately 20
seconds) ...
