Heating
This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and outboard vents.
1. Push the
button to the off position for
normal heating.
2. Turn the air flow control dial to the
position.
3. Turn the fan control dial to the desired position.
4. Turn the temperature control dial to the desired position between the middle and the hot position.
See also:
Forward-facing child restraint installation using the seat belts
WARNING:
The three-point seat belt with Automatic
Locking Retractor (ALR) must be used
when installing a child restraint. Failure to
use the ALR mode will result in the child
restraint not be ...
Installing top tether strap
First, secure the child restraint with the LATCH
lower anchors (rear outboard seat positions only)
or the seat belt, as applicable.
1. Flip up the anchor cover 1 from the anchor
point which is l ...
NISSAN Voice Recognition Standard Mode
The Standard Mode enables control of navigation,
phone and vehicle information. With this
setting active, commands that are available are
always shown on the display and announced by
the syste ...
