If the windows do not close automatically

Nissan Rogue / Nissan Rogue Owners Manual / Instruments and controls / Windows / Power windows / If the windows do not close automatically

If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system.

1. Turn the ignition switch to the ON position.

2. Close the door.

3. Open the window completely by operating the power window switch.

4. Pull the power window switch and hold it to close the window, and then hold the switch more than 3 seconds after the window is closed completely.

5. Release the power window switch. Operate the window by the automatic function to confirm the initialization is complete.

If the power window automatic function does not operate properly after performing the procedure above, have your vehicle checked by a NISSAN dealer.

    See also:

    Hood
    (1) Pull the hood lock release handle located below the driver side instrument panel. The hood will spring up slightly.  (2)- Push the lever at the front of the hood to the side as illu ...

    SAFETY
    The Murano CrossCabriolet has two sets of lower Latch anchors in the rear seats, but more importantly, the roomy backseat could easily house even the chunkiest infant carriers. With the top down ...

    Using the brakes
    Avoid resting your foot on the brake pedal while driving. This will overheat the brakes, wear out the brake pads faster, and reduce gas mileage. To help reduce brake wear and to prevent the brakes ...