Programming HomeLink® for Canadian customers
Prior to 1992, D.O.C. regulations required hand-held transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLink®, continue to push and hold the HomeLink® button (note steps 2 through 4 under “Programming HomeLink®”) while you push and re-push (“cycle”) your hand-held transmitter every 2 seconds until the indicator light flashes rapidly (indicating successful programming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener components.
See also:
Exterior and interior lights
* Always check with the Parts Department at a NISSAN dealer for the latest
parts information.
1. Front map lights (if so equipped)
2. Interior light
3. Headlight assembly
4. Front fog lig ...
NISSAN Vehicle Immobilizer System
The NISSAN Vehicle Immobilizer System will not
allow the engine to start without the use of the
registered key.
If the engine fails to start using the registered
key, it may be due to interfere ...
“Phonebook” (phones with automatic
phonebook download function)
NOTE:
The “Transfer Entry” command is not available
when the vehicle is moving.
For phones that support automatic download of
the phonebook (PBAP Bluetooth profile), the
“Phonebook” com ...