Programming HomeLink for Canadian customers
Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLink , continue to press and hold the HomeLink button (see steps 2 - 4 under “Programming HomeLink ”) while you press and repress (“cycle”) your hand-held transmitters every 2 seconds until the indicator light flashes rapidly (indicating successful programming).
NOTE:
When programming a garage door opener, etc., it is advised to unplug the device during the “cycling” process to prevent possible damage to the garage door opener components.
See also:
Troubleshooting guide
The system should respond correctly to all voice
commands without difficulty. If problems are encountered,
follow the solutions given in this guide
for the appropriate error.
Where the solutions a ...
Instrument panel
1. Headlight/fog light (if so equipped)
/turn signal switch; Manual
shift paddles (if so equipped)
2. Steering wheel switch for audio control
and Bluetooth Hands-Free Phone
System (if so e ...
HomeLink universal transceiver (if so equipped)
The HomeLink Universal Transceiver provides a
convenient way to consolidate the functions of up
to three individual hand-held transmitters into
one built-in device.
HomeLink Universal Transceiv ...