Programming trouble-diagnosis

If the HomeLink does not quickly learn the handheld transmitter information:

● replace the hand-held transmitter batteries with new batteries.

● position the hand-held transmitter with its battery area facing away from the HomeLink surface.

● press and hold both the HomeLink and hand-held transmitter buttons without interruption.

● position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink is not programmed within that time, try holding the transmitter in another position – keeping the indicator light in view at all times.

If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this manual.

    See also:

    Using the system
    The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given to ve ...

    Controls
    Automatic control button Push the AUTO button to activate the automatic climate control system for the passenger compartment. Fan control button Push the button to manually control the fan sp ...

    Pregnant women
    NISSAN recommends that pregnant women use seat belts. The seat belt should be worn snug, and always position the lap belt as low as possible around the hips, not the waist. Place the shoulder ...