Seat belts
The seat belts can be cleaned by wiping them with a sponge dampened in a mild soap solution. Allow the belts to dry completely in the shade before using them. See “Seat belt maintenance” in the “Safety – Seats, seat belts and supplemental restraint system” section of this manual.
WARNING
Do not allow wet seat belts to roll up in the retractor. NEVER use bleach, dye or chemical solvents to clean the seat belts, since these materials may severely weaken the seat belt webbing.
See also:
Rear Control Cancel Switch (if so equipped)
The rear control cancel switch operates when the
ignition switch is placed in the ACC or ON position.
The rear control cancel switch is located on the
left side of the instrument panel.
Pushin ...
On-pavement and off-road driving precautions
Utility vehicles have a significantly higher
rollover rate than other types of vehicles.
They have higher ground clearance than passenger
cars to make them capable of performing
in a variety of ...
Spark plugs
Be sure the engine and ignition switch
are off and that the parking brake is
engaged securely.
Be sure to use the correct socket to
remove the spark plugs. An incorrect
socket can dam ...