Removing covers from rear parcel shelf
Remove the top tether anchor cover or key cylinder cover as follows:
1. Lift the cover to the full open position.
2. Rotate the cover in the direction shown, disengaging the hinge at 1 and slide the second pin from the hinge 2 and remove the cover.
See also:
Clearing the programmed information
Individual buttons cannot be cleared. However,
to clear all programming, press and hold the two
outside buttons and release when the indicator
light begins to flash (approximately 20 seconds). ...
Engine compartment
Never use a fuse of a higher or lower
amperage rating than that specified on
the fuse box cover. This could damage
the electrical system or cause a fire.
If any electrical equipment does ...
Radio
Place the ignition switch in the ACC or ON
position and press the POWER/VOLUME control
knob to turn the radio on. If you listen to the
radio with the engine not running, the ignition
switch sh ...