Precautions on cruise control

● If the cruise control system malfunctions, it cancels automatically. The SET indicator light in the instrument panel then blinks to warn the driver.

● If the SET indicator light blinks, turn the cruise control switch off and have the system checked by a NISSAN dealer.

● The SET indicator light may blink when the cruise control switch is turned ON while pushing the ACCEL/RES, COAST/SET, or CANCEL switch. To properly set the cruise control system, use the following procedures.

WARNING

Do not use the cruise control when driving under the following conditions:
● When it is not possible to keep the vehicle at a set speed.
● In heavy traffic or in traffic that varies in speed.
● On winding or hilly roads.
● On slippery roads (rain, snow, ice, etc.).
● In very windy areas.
Doing so could cause a loss of vehicle control and result in an accident.

    See also:

    Engine compartment check locations
    MR20DE engine 1. Engine coolant reservoir 2. Engine oil filler cap 3. Brake fluid reservoir/Clutch fluid reservoir (M/T model) 4. Battery 5. Air cleaner 6. Fuse/Fusible link box 7. R ...

    Clearing the programmed information
    Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds) ...

    Car phone or CB radio
    When installing a CB, ham radio or car phone in your NISSAN, be sure to observe the following precautions; otherwise, the new equipment may adversely affect the engine control system and other ele ...