Moisture
Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for drying to avoid floor panel corrosion.
See also:
Reprogramming a single HomeLink button
To reprogram a HomeLink Universal Transceiver
button, complete the following.
1. Press and hold the desired HomeLink button.
Do not release the button until step 4
has been completed.
2. When the ...
Important information about this manual
You will see various symbols in this manual. They
are used in the following ways:
This is used to indicate the presence of
a hazard that could cause death or
serious personal injury. To avo ...
Releasing the trunk lid (if so equipped)
Releasing the trunk lid (if so equipped)
Press the button on the keyfob for longer
than 0.5 seconds to open the trunk lid. The trunk
release button on the keyfob will not operate
when the ig ...