Changing engine oil

MR20DE engine
MR20DE engine

A Oil filler cap
B Oil drain plug
C Oil filter

QR25DE engine
QR25DE engine

A Oil filler cap
B Oil drain plug
C Oil filter

1. Park the vehicle on a level surface and apply the parking brake.

2. Start the engine and let it idle until it reaches operating temperature, then turn it off.

3. Remove the oil filler cap A by turning it counterclockwise.

4. Place a large drain pan under the drain plug B .

5. Remove the drain plug B with a wrench by turning it counterclockwise and completely drain the oil.

If the oil filter is to be changed, remove and replace it at this time. See “Changing engine oil filter” later in this section.

● Waste oil must be disposed of properly.

● Check your local regulations.

● Prolonged and repeated contact with

● Prolonged and repeated contact with used engine oil may cause skin cancer.

● Try to avoid direct skin contact with used oil. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible.

● Keep used engine oil out of reach of children.

Be careful not to burn yourself. The engine

Be careful not to burn yourself. The engine oil may be hot.

6. Clean and reinstall the drain plug and a new washer. Securely tighten the drain plug with a wrench. Do not use excessive force.

Drain plug tightening torque.

22 - 29 ft-lb (29 - 39 N·m)

7. Refill engine with recommended oil through the oil filler opening, then install the oil filler cap securely.

See “Capacities and recommended fuel/lubricants” in the “Technical and consumer information” section of this manual for drain and refill capacity.

The drain and refill capacity depends on the oil temperature and drain time. Use these specifications for reference only. Always use the dipstick to determine when the proper amount of oil is in the engine.

8. Start the engine. Check for leakage around the drain plug and oil filter. Correct as required.

9. Turn the engine off and wait more than 10 minutes. Check the oil level with the dipstick.

Add engine oil if necessary.

MR20DE engine
MR20DE engine

A Oil filler cap
B Oil drain plug
C Oil filter

    See also:

    Keyfob
    Replace the battery in the keyfob as follows: 1. Remove the screw. 2. Insert a small screwdriver into the slit of the corner and twist it to separate the upper part from the lower part. Use a ...

    Tire and loading information label
    The cold tire pressure is shown on the Tire and Loading Information label. The label is located as shown. ...

    Rear-facing child restraint installation using LATCH
    Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint. Follow these steps to install a rear-facing child restraint ...