Automatic door locks
-All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h).
- All doors unlock automatically when the ignition switch is placed in the OFF position.
The automatic lock and unlock functions can be deactivated or activated independently of each other. To deactivate or activate the automatic door lock or unlock system, perform the following procedure:
1. Close all doors.
2. Place the ignition switch in the ON position.
3. Do one of the following within 20 seconds of performing Step #2:
- To change AUTO UNLOCK settings:
push and hold the power door lock switch
to the position 
(UNLOCK) for
more
than 5 seconds.
- To change AUTO LOCK settings: push
and hold the power door lock switch to
the position 
(LOCK) for more
than 5 seconds.
4. When activated, the hazard warning lights will flash twice. When deactivated, the hazard warning lights will flash once.
5. The ignition switch must be placed in the OFF and ON position again between each setting change.
See also:
Locking doors
Locking doors
1. Place the ignition switch in the LOCK position.
(Remove the key if any key is in the
ignition switch.)
2. Close all doors.
3. Push any door handle request switch 1
while ca ...
Locking with inside lock knob
Locking with inside lock knob
To lock the door without the key, move the inside
lock knob to the lock position 1 then close the
door.
To unlock, move the inside lock knob to the
unlock posit ...
Loading tips
● The GVW must not exceed GVWR
or GAWR as specified on the
F.M.V.S.S./C.M.V.S.S. certification
label.
● Do not load the front and rear axle to
the GAWR. Doing so will exceed the
...