Reprogramming a single HomeLink button
To reprogram a HomeLink Universal Transceiver button, complete the following.
1. Press and hold the desired HomeLink button. Do not release the button until step 4 has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface.
3. Press and hold the hand-held transmitter button.
4. The HomeLink indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons.
The HomeLink Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink button that was just programmed. This procedure will not affect any other programmed HomeLink buttons.
See also:
Instrument panel
Instrument panel
1. Side and center vents.
2. Headlight/fog light (if so equipped)/turn
signal switch.
3. Steering wheel switch for audio control
and Bluetooth Hands-Free Phone
System.
4. ...
Safety
Two notable safety improvements for 2010 include side curtain airbags as
standard equipment on all four- and six-cylinder models, and a standard
electronic stability system on all V-6 models. The ...
Using the panic alarm
If you are near your vehicle and feel threatened,
you may activate the panic alarm to call attention
by pressing and holding the button
on the
Intelligent Key for longer than 0.5 seconds.
The ...