Starting the vehicle

1. After starting the engine, fully depress the foot brake pedal before moving the shift selector out of the P (Park) position.

2. Keep the foot brake pedal depressed and move the shift selector into a driving gear.

3. Release the foot brake, then gradually start the vehicle in motion.

4. Stop the vehicle completely before shifting the shift selector to the P (Park) position. The CVT is designed so the foot brake pedal MUST be depressed before shifting from P (Park) to any drive position while the ignition switch is in the ON position. The shift selector cannot be moved out of P (Park) and into any of the other gear positions if the ignition switch is pushed to the LOCK position.

To move the shift selector:

To move the shift selector:

the Press the button while depressing the brake pedal

Shift without pressing button Press the button to shift

Shifting Shift without pressing button

    See also:

    Troubleshooting guide
    The system should respond correctly to all voice commands without difficulty. If problems are encountered, try the following solutions. Where the solutions are listed by number, try each soluti ...

    Manual operation (if so equipped)
    Tilt and telescopic operation Pull the lock lever (1) all the way towards you: - Adjust the steering wheel forward or backward in direction (2)- to the desired position. - Adjust the steering w ...

    Precautions on supplemental restraint system
    This Supplemental Restraint System (SRS) section contains important information concerning the following systems: - Driver and passenger supplemental frontimpact air bag (NISSAN Advanced Air Ba ...