Starting the vehicle

1. After starting the engine, fully depress the foot brake pedal before moving the shift selector out of the P (Park) position.

2. Keep the foot brake pedal depressed and move the shift selector into a driving gear.

3. Release the foot brake, then gradually start the vehicle in motion.

4. Stop the vehicle completely before shifting the shift selector to the P (Park) position. The CVT is designed so the foot brake pedal MUST be depressed before shifting from P (Park) to any drive position while the ignition switch is in the ON position. The shift selector cannot be moved out of P (Park) and into any of the other gear positions if the ignition switch is pushed to the LOCK position.

To move the shift selector:

To move the shift selector:

the Press the button while depressing the brake pedal

Shift without pressing button Press the button to shift

Shifting Shift without pressing button

    See also:

    Interior design
    Nissan Juke's active, sporting exterior is matched by its interior… where the dominant feature also displays a sense of fun: the centre console, finished in a high gloss paint, resembles a motor ...

    Unlocking doors
    Unlocking doors 1. Carry the Intelligent Key. 2. Push the door handle request switch 1 . 3. The hazard warning lights flash once and the outside buzzer sounds once. 4. Push the door handle req ...

    Fastening the seat belts
    1. Adjust the seat. See “Seats” earlier in this section. 2 Slowly pull the seat belt out of the retractor and insert the tongue into the buckle until you hear and feel the latch engage. & ...